HEIDENHAIN 548431-05 - Page 467

ICP programming | Contour elements on lateral surface
6
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
467
Vertical lines on lateral surface
Programming vertical lines:
Select the line direction
Enter the line dimensions
Define the transition to the next contour element
Parameters:
CY: Target point as linear dimension (reference: diameter XS)
CYi: Target point (incremental) as linear dimension (reference:
diameter XS)
C: Target point (polar angle)
P: Target point (in polar coordinates)
L: Line length
F: Further information: "Machining attributes", Page 418
ICP generates a G111 in smart.Turn mode of operation.
Horizontal lines on lateral surface
Programming horizontal lines:
Select the line direction
Enter the line dimensions
Define the transition to the next contour element
Parameters:
Z: Target point
Zi: Target point (incremental)
P: Target point (in polar coordinates)
L: Line length
F: Further information: "Machining attributes", Page 418
ICP generates a G111 in smart.Turn mode of operation.