Introduction and fundamentals | Features
1
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
47
Programming
Teach-in programming
Interactive contour programming (ICP)
smart.Turn programming
Automatic program creation with TURN PLUS
DINplus programming
Simulation
Graphic representation of the sequence of smart.Turn or
DINplus programs and graphic representation of a Teach-in cycle
or Teach-in program
Simulation of the tool paths as wire-frame or cutting-path
graphics, special identification of the rapid-traverse paths
Motion simulation (2-D material-removal graphic)
Side or face view, or 2-D view of cylindrical surface
Display of programmed contours
Shifting and magnifying functions
To Next Page
Loading...
