ICP programming | Contours in the YZ plane
6
524
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
Single surface in YZ plane
This function defines a surface in the YZ plane.
Reference data of YZ plane:
ID: Contour
C: Spindle angle
XR: Reference diameter
Parameters of single surface:
Z: Reference edge
Ki: Depth
K: Residual depth
B: Breadth (reference: Reference dimension ZR)
B < 0: Surface in negative Z direction
B > 0: Surface in positive Z direction
You can switch between Depth Ki and Residual depth K by soft
key.
You can use the Select reference plane function to determine the
Reference diameter XR.
Further information: "Reference data and nested contours",
Page 472
ICP generates the following:
The SURFACE Y section code with the Reference diameter
and Spindle angle parameters. The section code is omitted for
nested contours.
a G308 with the Contour name parameter
A G386 with the parameters of the single surface
A G309
Soft key
Switch the field to the input of Residual
depth K
To Next Page
Loading...
