Graphic simulation | Simulation submode
7
532
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
Soft keys with active simulation window
Call the warnings. If the interpreter issues
warnings during simulation (e.g. "Residual
material due to ..."), the soft key is activated
and the number of warnings is shown. Each
time the soft key is pressed, it switches to
the next warning
In Contin. run mode, all cycles of the
program are simulated in the Program run
submode without stopping
In Single block mode, the simulation stops
after each traverse path (basic block)
Open the soft-key menu for the zoom
function and display the zoom frame
Further information: "Adjusting the
displayed detail", Page 544
Switch the menu and the soft-key row to the
Miscellaneous functions
Change variables in Simulation submode
This soft key is only active if you are defining
variables in the PROGRAM HEAD section.
With the other menu items and the soft keys listed in the table,
you define the sequence of the simulation, activate the zoom
function, or use the miscellaneous functions to make settings for
the simulation.
You can operate the Simulation submode with the
numeric keys, even if the menu bar is not visible
In the Machine modes of operation, an activation
of the Single block soft key is also effective in
automatic mode
In the Machine modes of operation, you can start
automatic program run directly from the Simulation
submode with Cycle On
To Next Page
Loading...
