Graphic simulation | Dimensioning
7
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
551
Element dimensioning menu item
The Element dimensioning menu item is automatically active
after you have selected the dimensioning function. All data of
the marked contour element are shown in the display below the
graphic.
The arrow indicates the direction of the contour description
To next contour element: Press the Element forward/back soft
key
Change contour: Press the Previous contour or Next contour
soft key
The individual elements are measured for figures.
Point dimensioning menu item
The control displays the dimensions of the contour point relative to
the datum.
To next contour point: Press the Element forward/back soft key
Change contour: Press the Previous contour or Next contour
soft key
Menu item for setting the datum
This function is only available with point dimensioning. It enables
you to shift the datum and measure the distance to the datum.
Setting the datum:
Use the Element back soft key to select a new
datum
Select the Presetting menu item
The point symbol changes color
Use the Element back soft key to select the
point
The control displays the distance relative to the
selected datum
Menu item for canceling the datum
Canceling the datum:
Select the Preset from menu item
The set datum is canceled.
The displayed values once again reference the
original datum.
To Next Page
Loading...
