Graphic simulation | Settings
7
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
553
Change variables
In 2-D and 3-D simulation, you can Change variables defined in the
PROGRAM HEAD program section.
Change variables:
Press the Change variables soft key
You can now change the variables.
Press the Take over soft key
If you change variables during the Simulation, the
Simulation may be aborted.
C0 – Marking on workpiece/3D
In 3-D simulation, you can display the C0 marking on the
workpiece. This way, it is possible to check the position of C axis
machining:
0: Off – No C0 marking is displayed
1: On – The C0 marking is shown with a green line
This setting is volatile.
To Next Page
Loading...
