Tool and technology database | Tool editor mode of operation
8
572
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
HC: Holder type
A1: Boring bar holder
B1: Right-hand, short design
B2: Left-hand, short design
B3: Right-hand, short design, overhead
B4: Left-hand, short design, overhead
B5: Right-hand, long design
B6: Left-hand, long design
B7: Right-hand, long design, overhead
B8: Left-hand, long design, overhead
C1: Right-hand
C2: Left-hand
C3: Right-hand, overhead
C4: Left-hand, overhead
D1: Multicarrier
A: Boring bar holder
B: Drill holder with coolant supply
C: Square, longitudinal
D: Square, transverse
E: Rear-face machining
E1: U drill
E2: Cylindrical shank holder
E3: Collet chuck holder
F: Drill holder MK (Morse taper)
K: Drill chuck
T1: Driven, axial
T2: Driven, radial
T3: Boring bar holder
X5: Driven, axial
X6: Driven, radial
MP: Tool position in turret
0: –Z direction
1: –X/–Z direction
2: –X/+Z direction
3: +Z direction
WH: Height of holder
WB: Width of holder
AT: Holder type
WHT: Halter Tiefe (default: parameter WB)
TOF: Versatz für Tiefe (default: parameter WHT/2)
Only ASCII characters are allowed for holder names in
the tool holder table. Diacritics or Asian characters are
not allowed.
You can also view and edit the tool holder table in open
tool forms. Use the Holder editor soft key for this
purpose.
To Next Page
Loading...
