HEIDENHAIN TNC 320 - Page 125

OUTSIDE THREAD MILLING (Cycle 267, DIN/ISO: G267) 4.10
4
HEIDENHAIN | TNC 320 | User’s manual for cycle programming | 9/2016
125
Q254 Feed rate for counterboring?: Traversing
speed of the tool in mm/min during countersinking.
Input range 0 to 99999.9999 alternatively FAUTO,
FU
Q207 Feed rate for milling?: Traversing speed of
the tool in mm/min during milling. Input range 0 to
99999.999 alternatively FAUTO
Q512 Feed rate for approaching?: Traversing
speed of the tool in mm/min while approaching.
For smaller thread diameters you can decrease
the approaching feed rate in order to reduce the
danger of tool breakage. Input range 0 to 99999.999
alternatively FAUTO
Q355=0 ;THREADS PER STEP
Q253=750 ;F PRE-POSITIONING
Q351=+1 ;CLIMB OR UP-CUT
Q200=2 ;SET-UP CLEARANCE
Q358=+0 ;DEPTH AT FRONT
Q359=+0 ;OFFSET AT FRONT
Q203=+30 ;SURFACE COORDINATE
Q204=50 ;2ND SET-UP
CLEARANCE
Q254=150 ;F COUNTERBORING
Q207=500 ;FEED RATE FOR
MILLNG
Q512=0 ;FEED FOR APPROACH