RECTANGULAR POCKET (Cycle 251, DIN/ISO: G251) 5.2
5
HEIDENHAIN | TNC 320 | User’s manual for cycle programming | 9/2016
135
Q385 Finishing feed rate?: Traversing speed of the
tool in mm/min during side and floor finishing. Input
range 0 to 99999.999, alternatively FAUTO, FU, FZ
Q439 Feed rate reference (0-3)?: Specify what the
programmed feed rate refers to:
0: Feed rate with respect to the tool center point
path
1: Feed rate with respect to the tool edge, but only
during side finishing, otherwise with respect to the
tool center point path
2: Feed rate refers to the tool cutting edge during
side finishing and floor finishing; otherwise it refers
to the tool path center
3: Feed rate always refers to the cutting edge
Q200=2 ;SET-UP CLEARANCE
Q203=+0 ;SURFACE COORDINATE
Q204=50 ;2ND SET-UP
CLEARANCE
Q370=1 ;TOOL PATH OVERLAP
Q366=1 ;PLUNGE
Q385=500 ;FINISHING FEED RATE
Q439=0 ;FEED RATE REFERENCE
9 L X+50 Y+50 R0 FMAX M3 M99
To Next Page
Loading...
