HEIDENHAIN TNC 320 - Page 18

Contents
18
HEIDENHAIN | TNC 320 | User’s manual for cycle programming | 9/2016
3.9 BORE MILLING (Cycle 208).................................................................................................................. 85
Cycle run................................................................................................................................................. 85
Please note while programming:............................................................................................................85
Cycle parameters.................................................................................................................................... 86
3.10 SINGLE-LIP DEEP-HOLE DRILLING (Cycle 241, DIN/ISO: G241)....................................................... 87
Cycle run................................................................................................................................................. 87
Please note while programming:............................................................................................................87
Cycle parameters.................................................................................................................................... 88
3.11 Programming Examples....................................................................................................................... 90
Example: Drilling cycles.......................................................................................................................... 90
Example: Using drilling cycles in connection with PATTERN DEF..........................................................91