HEIDENHAIN TNC 320 - Page 20

Contents
20
HEIDENHAIN | TNC 320 | User’s manual for cycle programming | 9/2016
4.9 HELICAL THREAD DRILLING/MILLING (Cycle 265, DIN/ISO: G265)...............................................118
Cycle run............................................................................................................................................... 118
Please note while programming:..........................................................................................................119
Cycle parameters.................................................................................................................................. 120
4.10 OUTSIDE THREAD MILLING (Cycle 267, DIN/ISO: G267)................................................................122
Cycle run............................................................................................................................................... 122
Please note while programming:..........................................................................................................123
Cycle parameters.................................................................................................................................. 124
4.11 Programming Examples..................................................................................................................... 126
Example: Thread milling........................................................................................................................126