HEIDENHAIN TNC 320 - Page 26

Contents
26
HEIDENHAIN | TNC 320 | User’s manual for cycle programming | 9/2016
8 Fixed Cycles: Cylindrical Surface................................................................................................ 217
8.1 Fundamentals...................................................................................................................................... 218
Overview of cylindrical surface cycles..................................................................................................218
8.2 CYLINDER SURFACE (Cycle 27, DIN/ISO: G127, software option 1)............................................... 219
Cycle run............................................................................................................................................... 219
Please note while programming:..........................................................................................................220
Cycle parameters.................................................................................................................................. 221
8.3 CYLINDER SURFACE Slot milling (Cycle 28, DIN/ISO: G128, software option 1)......................... 222
Cycle run............................................................................................................................................... 222
Please note while programming:..........................................................................................................223
Cycle parameters.................................................................................................................................. 224
8.4 CYLINDER SURFACE Ridge milling (Cycle 29, DIN/ISO: G129, software option 1).......................225
Cycle run............................................................................................................................................... 225
Please note while programming:..........................................................................................................226
Cycle parameters.................................................................................................................................. 227
8.5 CYLINDER SURFACE (Cycle 39, DIN/ISO: G139, software option 1)..............................................228
Cycle run............................................................................................................................................... 228
Please note while programming:..........................................................................................................229
Cycle parameters.................................................................................................................................. 230
8.6 Programming Examples..................................................................................................................... 231
Example: Cylinder surface with Cycle 27............................................................................................. 231
Example: Cylinder surface with Cycle 28............................................................................................. 233