HEIDENHAIN TNC 320 - Page 29

HEIDENHAIN | TNC 320 | User’s manual for cycle programming | 9/2016
29
10.8 AXIS-SPECIFIC SCALING (Cycle 26)..................................................................................................263
Effect..................................................................................................................................................... 263
Please note while programming:..........................................................................................................263
Cycle parameters.................................................................................................................................. 264
10.9 WORKING PLANE (Cycle 19, DIN/ISO: G80, software option 1).....................................................265
Effect..................................................................................................................................................... 265
Please note while programming:..........................................................................................................266
Cycle parameters.................................................................................................................................. 266
Resetting............................................................................................................................................... 266
Positioning the axes of rotation............................................................................................................267
Position display in a tilted system........................................................................................................ 268
Monitoring of the working space......................................................................................................... 268
Positioning in a tilted coordinate system..............................................................................................269
Combining coordinate transformation cycles........................................................................................269
Procedure for working with Cycle 19 WORKING PLANE.....................................................................270
10.10 Programming Examples..................................................................................................................... 271
Example: Coordinate transformation cycles......................................................................................... 271