HEIDENHAIN TNC 320 - Page 308

Touch Probe Cycles: Automatic Measurement of Workpiece Misalignment
13.2 BASIC ROTATION (Cycle 400, DIN/ISO: G400)
13
308
HEIDENHAIN | TNC 320 | User’s manual for cycle programming | 9/2016
Q307 Preset value for rotation angle (absolute):
If the misalignment is to be measured against a
straight line other than the reference axis, enter
the angle of this reference line. The TNC will
then calculate the difference between the value
measured and the angle of the reference line for the
basic rotation. Input range -360.000 to 360.000
Q305 Preset number in table?: Enter the preset
number in the table in which the TNC is to save the
determined basic rotation. If you enter Q305=0,
the TNC automatically places the determined basic
rotation in the ROT menu of the Manual Operation
mode. Input range 0 to 99999