HEIDENHAIN TNC 320 - Page 355

DATUM FROM OUTSIDE OF CORNER (Cycle 414, DIN/ISO: G414) 14.8
14
HEIDENHAIN | TNC 320 | User’s manual for cycle programming | 9/2016
355
Q383 Probe TS axis: Coord. 2nd axis? (absolute):
Coordinate of the probe point in the minor axis of
the working plane at which point the datum is to be
set in the touch probe axis. Only effective if Q381 =
1. Input range -99999.9999 to 99999.9999
Q384 Probe TS axis: Coord. 3rd axis? (absolute):
Coordinate of the probe point in the touch probe
axis, at which point the datum is to be set in the
touch probe axis. Only effective if Q381 = 1. Input
range -99999.9999 to 99999.9999
Q333 New datum in TS axis? (absolute): Coordinate
in the touch probe axis at which the TNC should
set the datum. Default setting = 0. Input range
-99999.9999 to 99999.9999