Touch Probe Cycles: Automatic Workpiece Inspection
15.4 MEASURE ANGLE (Cycle 420, DIN/ISO: G420)
15
386
HEIDENHAIN | TNC 320 | User’s manual for cycle programming | 9/2016
Q260 Clearance height? (absolute): coordinate in
the touch probe axis at which no collision between
tool and workpiece (fixtures) can occur. Input range
-99999.9999 to 99999.9999
Q301 Move to clearance height (0/1)?: Definition
of how the touch probe is to move between the
measuring points:
0: Move at measuring height between measuring
points
1: Move at clearance height between measuring
points
Q281 Measuring log (0/1/2)?: Define whether the
TNC should create a measuring log:
0: Do not create a measuring log
1: Create a measuring log: The TNC saves the log
file TCHPR420.TXT as standard in the directory
TNC:\.
2: Interrupt program run and output measuring log
to the TNC screen. Resume program run with NC
Start.
Q320=0 ;SET-UP CLEARANCE
Q260=+10 ;CLEARANCE HEIGHT
Q301=1 ;MOVE TO CLEARANCE
Q281=1 ;MEASURING LOG
To Next Page
Loading...
