Touch Probe Cycles: Automatic Workpiece Inspection
15.6 MEASURE HOLE OUTSIDE (Cycle 422, DIN/ISO: G422)
15
394
HEIDENHAIN | TNC 320 | User’s manual for cycle programming | 9/2016
Q365 Type of traverse? Line=0/arc=1: Definition
of the path function with which the tool is to move
between the measuring points if "traverse to
clearance height" (Q301=1) is active:
0: Move in a straight line between machining
operations
1: Move in a circular arc on the pitch circle diameter
between machining operations
Parameters Q498 and Q531 have no effect in this
cycle. You do not need to make any entries. These
parameters have only been integrated for reasons of
compatibility. If, for example, you import a program
of the contouring control for turning and milling,
TNC 640, you will not receive an error message.
To Next Page
Loading...
