HEIDENHAIN TNC 320 - Page 397

MEASURE RECTANGLE INSIDE (Cycle 423, DIN/ISO: G423) 15.7
15
HEIDENHAIN | TNC 320 | User’s manual for cycle programming | 9/2016
397
Q281 Measuring log (0/1/2)?: Define whether the
TNC should create a measuring log:
0: Do not create a measuring log
1: Create a measuring log: The TNC saves the log
file TCHPR423.TXT as standard in the directory
TNC:\.
2: Interrupt program run and output measuring log
to the TNC screen. Resume program run with NC
Start.
Q309 PGM stop if tolerance exceeded?: Definition
of whether in the event of a violation of tolerance
limits the TNC is to interrupt program run and output
an error message:
0: Do not interrupt program run, do not output an
error message
1: Interrupt program run and output an error
message
Q330 Tool for monitoring?: Definition of
whether the TNC is to monitor the tool (see "Tool
monitoring", page 380). Input range 0 to 32767.9,
alternatively tool name with maximum of 16
characters
0: Monitoring inactive
>0: Tool number in the tool table TOOL.T