HEIDENHAIN TNC 320 - Page 406

Touch Probe Cycles: Automatic Workpiece Inspection
15.10 MEASURE RIDGE WIDTH (Cycle 426, DIN/ISO: G426)
15
406
HEIDENHAIN | TNC 320 | User’s manual for cycle programming | 9/2016
Q309 PGM stop if tolerance exceeded?: Definition
of whether in the event of a violation of tolerance
limits the TNC is to interrupt program run and output
an error message:
0: Do not interrupt program run, do not output an
error message
1: Interrupt program run and output an error
message
Q330 Tool for monitoring?: Definition of
whether the TNC is to monitor the tool (see "Tool
monitoring", page 380). Input range 0 to 32767.9,
alternatively tool name with maximum of 16
characters
0: Monitoring inactive
>0: Number or name of the tool that the TNC used
for machining. You are able to apply a tool via soft
key directly from the tool table.