CALIBRATE TS LENGTH (Cycle 461, DIN/ISO: G461) 16.8
16
HEIDENHAIN | TNC 320 | User’s manual for cycle programming | 9/2016
437
Please note while programming:
HEIDENHAIN only gives warranty for the function of
the probing cycles if HEIDENHAIN touch probes are
used.
The effective length of the touch probe is always
referenced to the tool datum. The machine tool
builder usually defines the spindle tip as the tool
datum.
Before a cycle definition you must have programmed
a tool call to define the touch probe axis.
A measuring log is created automatically during
calibration. The log file is named TCHPRAUTO.html.
Q434 Datum for length? (absolute): Datum for the
length (e.g. height of the ring gauge). Input range
-99999.9999 to 99999.9999
NC blocks
5 TCH PROBE 461 TS CALIBRATION OF
TOOL LENGTH
Q434=+5 ;PRESET
To Next Page
Loading...
