Fundamentals / Overviews
1.2 Available Cycle Groups
1
44
HEIDENHAIN | TNC 320 | User’s manual for cycle programming | 9/2016
Overview of touch probe cycles
The soft-key row shows the available groups of
cycles
Soft key Cycle group Page
Cycles for automatic measurement and compensation of workpiece
misalignment
304
Cycles for automatic workpiece presetting 324
Cycles for automatic workpiece inspection 376
Special cycles 420
Touch probe calibration 432
Cycles for automatic kinematics measurement 304
Cycles for automatic tool measurement (enabled by the machine tool
builder)
444
If required, switch to machine-specific touch
probe cycles. These touch probe cycles can be
integrated by your machine tool builder.
To Next Page
Loading...
