SAFETY
3-2 MS 3000 • 9095-032A
Material must never extend
beyond the outer limits of the
platform. Items which may roll
must be properly secured.
Materials must never be stacked
against the fencing.
If work must be carried on close
to high voltage cables, a
minimum safety distance of
15 m must be maintained.
When materials and/or tools with
a large surface area will be used
contact your supplier in
connection with wind sensitivity.
- If the machine is to be used during the
hours of darkness, the area must be
adequately lit, so that the user has a
good view in all conditions.
- In order to ensure that no person
unintentionally walks under the platform,
the mast climbing work platform must be
surrounded with suitable fencing.
- The machine may only be used for the
purpose for which it was designed, that
is, the vertical transportation of persons
and materials with a maximum weight
within the design limits of the particular
construction.
- Loads (materials, persons, etc.) must
be distributed in accordance with the
loading diagram.
- Operations on the mast climbing work
platform may only be carried out by
persons with adequate knowledge and
qualifications to do so.
- Inspection and maintenance must be
carried out as given in this instruction
manual.
- During assembly and maintenance, the
mast climbing work platform may not be
used for other purposes.
- Keep hatches in the base of the
platform clear. From the platform it must
be possible to get, to the emergency
descent controls via the hatches.
- The competence and sense of
responsibility of the operator or
engineer are essential to the efficient
use of the platform.
- Local safety laws and regulations must
always be followed.
- Technical personnel must be in a
position to deal with any difficulty
encountered in every possible situation
during assembly and disassembly. The
operating personnel must be familiar
with those situations which can occur
during use.
- If operating or technical personnel report
errors or dangers or are aware of the
safety regulations, the owner or the
person responsible must be informed
immediately.
- The working area must be kept free
from obstacles (building materials, dirt,
snow, etc.).
- Fences must never removed during
normal use.
- The platform must only be entered and/
or loaded when it is in its lowest
position. The same rule applies to
leaving the platform.
- When electrical storms are expected,
work on the platform must be stopped in
time to avoid the danger of lightening
strikes. The power supply must be
switched off and the connector
withdrawn from the supply socket.
- Platform extensions on telescopic
supports may only be used to carry
personnel. Such personnel may only
stand on these extensions when the
machine is stationary.
- If erecting two adjacent platforms there
must be a clear gap between the ends
of the platforms of at least 0,5 meter.
To Next Page
Loading...
Need help?
General