ASSEMBLY AND ANCHORING
6-9MS 3000 • 9095-032A
7. Stand on the platform and place a
mast element on the last element
assembled using the crane if
required. Secure the mast element
with four bolts, washers and nuts.
Tighten the bolts to the specified
torque (See chapter 1).
8. Raise the platform towards the top
of the mast element and repeat the
procedure until another element
must be assembled. Plan the
procedure so that, when an anchor
must be fitted, the loading of
material and mast elements is a
minimum.
9. Ensure that anchors are placed at
the specified intervals.
10. Repeat this working method until
the mast has reached the required
height. Finally, the mechanical end
stop must be attached to the left-
hand mast. The maximum specified
height must not be exceeded.
11. If a crane is available on the
building site, the mast can be more
quickly assembled. Up to four mast
elements can be assembled on the
ground and then raised into position
with the crane.
12. The mast must not extend too far
above the uppermost anchor (See
chapter 1). To achieve good stability,
it is always better to place an
anchor as close to the top of the
mast as possible.
13. Assemble the mast cover panels
from the platform and secure them.
14. The assembly is now complete. The
assembly must now be tested as
described in section 7.1
Fig.6-13 Mast element with mechanical end stop
Fig.6-14 Mast cover