OPERATION
7-3MS 3000 • 9095-032A
Fig.7-3 Brake lever platform
7.3 Testing
1. Test the platform and check the
following:
- all limit switches, striker plates and
safety devices and ensure that
everything is properly adjusted.
- that the path of the platform is not
obstructed.
- the functioning of all the push
buttons on the control box.
- the free movement of the power
supply cable.
Also test the platform brakes! (see
section 7.4)
7.4 Brake test
The brake test must be carried out daily.
1. Release the brake on one of the
motors by pulling the lever on the
motor. The platform should not
descend. Release the brake lever.
2. Release the other brake. The
platform should not descend.
Release the brake lever.
If the platform descends, the
mast climbing work platform
must not be used. Consult the
service engineer.
To Next Page
Loading...
Need help?
General