EasyManuals Logo

HEK MS 3000 User Manual

HEK MS 3000
66 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #26 background imageLoading...
Page #26 background image
TRANSPORT
4-2 MS 3000 9095-032A
Fig.4-2 Locking pin outrigger chassis
4.1 Repositioning on the building site
Ensure that trees, power cables
etc., cannot be touched.
During movement there may be
no load on the platform.
Once on the building site, the mast
climbing work platform can be moved in
the lowest position on its chassis.
The plug of the power supply must be
removed.
On a hard flat horizontal surface and
when there is no wind, the mast may
have a maximum height of 8 m during
repositioning. The platform must be on
the buffers. The legs must be set out and
secured. The jack must be screwed out
until they are just clear the ground.
When the circumstances are
unfavourable than the above mentioned
circumstances, contact your supplier.
The chassis can be moved behind a
vehicle.
The maximum speed at which the
chassis may be towed behind a vehicle is
30 m/min.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HEK MS 3000 and is the answer not in the manual?

HEK MS 3000 Specifications

General IconGeneral
BrandHEK
ModelMS 3000
CategoryConstruction Equipment
LanguageEnglish