î Stop the engine.
ENGINE OIL REPLACEMENT
PROCESS
î To drain the oil, remove the oil level dipstick
and drain plug (1) and washer (2).
î After the oil has completely drained, replace
the sealing washer is in good condition and
reinstall the drain plug.
î Make sure that oil level is at the upper
level mark of the oil level dipstick with the
motorcycle in an upright position, and that
there are no oil leaks.
î Reinstall the oil level dipstick.
Drain engine oil with the engine warm and
park the motorcycle on its main stand.
î Fill the crankcase through the oil filer hole
with approximately 1.0 litre oil.
î Start the engine and allow it to idle for few
minutes.
1
2
(1) Drain bolt (2) Sealing washer
î Running the engine with excessive oil can
cause spark plug fouling & loss in
performance.
î Running the engine with insufficient
oil can cause serious engine damage.
î Engine oil is a major factor affecting the
performance and service life of the engine.
Non-detergent, vegetable or castor based
racing oils are not recommended.
CAUTION
To safely operate your motorcycle, your tyres
must be of the proper type and size, in good
condition with adequate tread, and correctly
inflated for the load you are carrying. The
following pages give more detailed
information on how and when to check the air
pressure, how to inspect your tyres for
damage, and what to do when your tyres need
to be repaired or replaced.
The tyres fitted on your motorcycles are of
TUBELESS type.
TYRES
î Using tyres that are excessively worn or
improperly inflated can cause a crash in
which you can be seriously hurt or killed.
î Follow all instruction in this owner’s manual
regarding tyre inflation and maintenance.
WARNING
Keeping your tyres properly inflated provides
the best combination of handling, tread life
and riding comfort. Generally, under-inflated
tyres wear unevenly, adversely affect handling
Air Pressure
22
To Next Page
Loading...
