Before inserting the feeler gauge, smear a bit
of engine oil to avoid damage to the feeler gauge.
NOTE
Carburetor (Idle speed)
achieve optimum performance and meet
emission standards.
î Warm up the engine and park the
motorcycle on the main stand.
î Adjust idle speed with the throttle stop
screw (1).
However in case of specific requirement of
tuning due to engine stalling in idle speed, please
follow the instructions given here under:
IDLE SPEED: 1400 ± 100 r/min
The carburetor is factory pre-set in order to
Do not attempt to compensate for faults in
other systems by adjusting idle speed. Visit
your Authorised Hero MotoCorp workshop
for scheduled carburetor adjustment.
CAUTION
(1) Throttle stop screw
(A) Decrease r/min (B) Increase r/min
A
B
1
Clutch adjustment may be required if the
motorcycle stalls when shifting into gear or
tends to creep or if the clutch slips, causing
acceleration to lag behind engine speed.
Normal clutch lever free play (1) is 10-20
mm at the lever (2).
CLUTCH
2
1
(1) Free play 10-20 mm (2) Clutch lever
3
4
B
A
(3) Lock nut (4) Clutch cable adjusting nut
(A) Decrease free play (B) Increase free play
37
To Next Page
Loading...
