DVI & VGA
V-Switch quad II supports resolutions of up to 1920 x 1200 @ 60 Hz for both DVI and VGA.
Any combination of VGA and DVI at all standard resolutions is possible at inputs and output. Analog video input
is converted to digital. If an analog display is connected, V-Switch quad II converts the digital signal to analog at
the output. Internally, V-Switch quad II processes video purely digital guaranteeing best digital image quality.
USB & PS/2 for keyboard / mouse / touch screen / trackball
Use either PS/2 or USB ports on the computer to connect keyboard and mouse to V-Switch quad II. It supports
any combination.
To connect the console, V-Switch quad II features two USB ports for mouse, keyboard, touchscreen or trackball
connection.
Transparent USB 2.0
V-Switch quad II features a transparent high speed USB 2.0 matrix: USB 2.0 devices (e.g. printer, external
memory, memory stick,webcam, 3D mouse, finger printer) can be switched to computers connected.
Operation
There are six ways to operate V-Switch quad II, switch channels, and select display modes:
1. Using the buttons on the front of the unit
2. Using configurable hotkeys
3. Using the unit’s external configuration program on a remote computer
4. Via a serial port using the protocol DCP XML
5. Using mouse functions (Hotmouse)
6. Using a touch screen
The configuration of V-Switch quad II is effected via an On Screen Display (OSD) opened and navigated either
with keyboard commands or front panel buttons or remotely via ConfDev on an external PC.
The LEDs on the front panel indicate the unit’s current status.
Use the serial (RS232) port for remote control and firmware updates.
FEATURES
To Next Page
Loading...
General