Hettich AG, Seestrasse 204a, 8806 Baech, Switzerland Operator_Manual_Rotolavit II_und_Rotolavit II-S_en_rev2.5
Seite 13
4 Behaviour in case of malfunctions and irregularities
The device may only be used in a flawless condition. If you as the operator notice irregularities, malfunctions or
damage, immediately take the device out of work and inform your superior.
You can find on correcting malfunctions in chapter 13.
4.1 Remaining risks
The device is built according to the state-of-the-art and the recognized safety regulations. If used and handled
improperly, there could be life-threatening danger to the user or third parties, the device could be impaired or
there could be other property damage. The device is only to be used for its intended purpose and only when it is
in safe working condition. Malfunctions which could affect safety must be corrected immediately.
4.2 Switching off the device in an emergency
Push the on / off switch on the rear-panel to its off-position and disconnect the power plug. This
disconnects the device from the power supply at all poles.
4.3 Emergency release
The lid cannot be opened during power failure. An emergency release has to be executed by hand.
For emergency release disconnect the centrifuge from the mains.
Open the lid only during rotor standstill.
Only the plastic release pin provided may be used for emergency release.
Switch off the mains switch (switch position "0").
Look through the window in the lid to be sure that the rotor has come to a standstill.
Insert the release pin horizontally into the hole. Push the unlocking pin in until the handle can be lifted when
the pin is pressed in.
Open the lid.
An error appears on the display after switching on the centrifuge.
To Next Page
Loading...
Need help?
General
