Hettich AG, Seestrasse 204a, 8806 Baech, Switzerland Operator_Manual_Rotolavit II_und_Rotolavit II-S_en_rev2.5
Seite 34
Add the physiological saline directly into the tubes
via the distributor of the rotating rotor to get a good
resuspension of the cells. For this purpose, a speed
range from 0 rpm to 2500 rpm is available. The fill
volume to be set per tube is between 0.1 ml and 10
ml. The default value is 3.5 ml at 1100 rpm.
Filling in the secondary solution.
For this purpose, a speed range from 0 rpm to 2500
rpm is available. The fill volume to be set per tube is
between 0.1 ml and 10 ml. The default value is 3.5
ml at 1100 rpm.
9.4 Process descriptions
9.4.1 Principle
A program can have a maximum of 20 different processes, but only with 1 LOOP process. It does not matter
with which process a program starts, except with a LOOP process or a CHECK process and it can also have
only one of these processes.
9.4.2 FILL 1 process
The best results are with a speed of 1100 rpm for both kinds of rotor types.
The device will calculate the complete volume itself for the preselected rotor.
9.4.3 FILL 2 process
Only selectable if your device has installed the optional second pump
(part number 1008-02 and 1008-04)
To Next Page
Loading...
Need help?
General
