Hettich AG, Seestrasse 204a, 8806 Baech, Switzerland Operator_Manual_Rotolavit II_und_Rotolavit II-S_en_rev2.5
Seite 31
1. Pre-installed system programs
2. Pre-installed user programs for the device types
1008-00 and 1008-03
Pre-installed user programs only for the
device type 1008-00S:
- cell recovery
- immunophenotyping
9.3 Pre-installed programs
9.3.1 flush
This pre-installed system program is designed to flush (clean) the external and the internal tubing system with
deionized or demineralized water after the routine so no salt crystals are built.
Before the routine, the tube system must be rinsed with saline.
If you delete this program, only a specialist can reload it.
9.3.2 refill pump
This pre-installed system program is designed to refill the external and the internal tubing system with the used
and needed solution without spinning the rotor. It will also ignore air bubbles in the system.
If you delete this program, only a specialist can reload it.
To Next Page
Loading...
Need help?
General
