Page 4-6 December 2016
Printer Preferences PLT-01668, Version: 1.2
4.1.1.4 Safety Messages (Review Carefully)
Note: All messages are provided in English and French.
Symbol Critical Instructions for Safety Purposes
Danger:
Failure to follow these installation guidelines can result in death or serious injury.
Information that raises potential safety issues is indicated by a warning symbol (as shown to
the left).
• To prevent personal injury, refer to the following safety messages before performing an
operation preceded by this symbol.
• To prevent personal injury, always remove the power cord prior to performing repair
procedures, unless otherwise specified.
• To prevent personal injury, make sure only qualified personnel perform these
procedures.
Attention:
Le non respect de ces consignes d'installation peut entraîner la mort ou des blessures graves.
L'information qui pose des problèmes de sécurité potentiels sont signalées par un symbole
d'avertissement (comme illustré à gauche).
• Pour éviter toute blessure, consultez les consignes de sécurité suivantes avant
d'effectuer une opération précédée par ce symbole.
• Pour éviter toute blessure, débranchez toujours le cordon d'alimentation avant
d'effectuer les procédures de réparation, sauf indication contraire.
• Pour éviter toute blessure, assurez-vous que seul le personnel qualifié est chargé de ces
procédures.
Caution:
This device is electrostatically sensitive. It may be damaged if exposed to static electricity
discharges.
Information that raises potential electrostatic safety issues is indicated by a warning symbol
(as shown to the left).
• To prevent equipment or media damage, refer to the following safety messages before
performing an operation preceded by this symbol.
• To prevent equipment or media damage, observe all established Electrostatic Discharge
(ESD) procedures while handling cables in or near the circuit board and printhead
assemblies.
• To prevent equipment or media damage, always wear an appropriate personal
grounding device (e.g., a high quality wrist strap grounded to avoid potential damage).
• To prevent equipment or media damage, always remove the Ribbon and Cards from the
Printer before making any repairs, unless otherwise specified.
• To prevent equipment or media damage, take jewelery off of fingers and hands, as well
as thoroughly clean hands to remove oil and debris before working on the printer.
To Next Page
Loading...
Need help?
General