December 2016 Page 2-3
PLT-01668, Version: 1.2 Setup and Installation Procedures
3. Close the front cover.
2.4 Installing Blank Cards into the Input Card Hopper
The FARGO DTC1250e, DTC1000Me and DTC4250e Card Printers are capable of printing single feed
cards and multiple feed cards (batch mode). To print a single feed card, remove all cards from the
input card hopper, leave its door closed and place a card in the single feed card slot (which can be
used repeatedly).
1. Load the cards with the print side down and (if applicable) the magnetic strip up and towards
the front of the printer.
Information: Do not run the cards with a contaminated, dull or uneven surface through the
Printer. Printing onto these cards may lead to poor print quality and can greatly reduce the life
of the printhead.
Card types include PVC or PVC finish.
Cards eject into the output hopper or reject hopper.
Each input hopper holds 100 cards.
Certain types of smart card chips are raised slightly above the cards surface, which may
result in poor color transfer. Design the card with white space surrounding the chip.
2. Open the input card hopper door.
DTC4250e with Flipper ModuleDTC1250e/DTC1000Me
To Next Page
Loading...
Need help?
General