Hikmicro ALPEX LRF 4K Series User Manual

Digital Day & Night Vision Scope User Manual
9
Power Off
When the device is turned on, hold to power off the device.
Note

Power-off countdown will appear when you power off the device. You
can press any key to interrupt the countdown and cancel the power-off.

Automatic low battery power-off cannot be canceled.
Auto Power Off
You can set the auto power off time for your device.
Steps
1. Hold the wheel to show the menu.
2. Go to Advanced Settings, and select General Settings.
3. Rotate the wheel to select , and press the wheel to enter the
configuration interface.
4. Rotate the wheel to select the auto power off time as required, and
press the wheel to confirm.
5. Hold the wheel to save and exit.
Note

See the battery icon for the battery status. means the battery is
fully charged, means that the battery is low, and means the
battery charging is abnormal.

When the low power note shows, charge the battery.

The auto power off takes effect only when the device enters the
standby mode and the device isn’t connected with HIKMICRO Sight app
at the same time.

The auto power off countdown will start again when the device reenters
standby mode, or the device is restarted.
2.6 Auto Screen Off
Auto screen off function darkens the screen to save energy and increase
battery time.
Steps

Hikmicro ALPEX LRF 4K Series Specifications

General

Frame Rate	50 Hz
Laser Rangefinder	Yes
IP Rating	IP67
Sensor Resolution	384 × 288
Detection Range	1800m
Display	0.39 inch, OLED
Laser Rangefinder Range	1000 m
Battery Type	Rechargeable Li-ion Battery
Weight	Approx. 980 g
Operating Temperature	-30°C to 55°C
Storage Temperature	-30°C to 60°C
Objective Lens	50 mm
Battery Life	8 hours