Digital Day & Night Vision Scope User Manual
24
Note
When you switch the reticle No., a prompt will appear on the interface.
Select OK to save the parameters for the current reticle.
When enabling the freeze function in reticle, you can adjust the position
of the cursor on a frozen image. This function can prevent image flutter.
7. Hold the wheel to exit the setting interface according to the prompt.
OK: Save the parameter and exit.
CANCEL: Exit but not save the parameters.
8. Pull the trigger again to verify that the aiming point aligns with the point
of impact.
9. (Optional) Repeat 3 to 8 to set the position for other reticles in this
zeroing profile.
You can also correct the reticle by HIKMICRO Sight app.
Before You Start
Install HIKMICRO Sight on your phone.
Step
1. Open HIKMICRO Sight and connect your device to the app.
2. Tap Product Info, and tap Zero to enter configuration interface.
3. Set reticle to the target.
After synchronizing data from the device, select a zeroing profile.
Select a reticle you want to correct.
Input the number to set the distance to the target.
Select digital zoom ratio.
4. After synchronizing parameters to the device, aim at the target and pull
the trigger.
5. Measure the deviation of the point of impact from the target, and input
the number to adjust the position of reticle until the big reticle aligns
with the point of impact.
6. (Optional) Tap Next Profile for to set the position for other reticles.
Result
To Next Page
Loading...
Need help?
General
