HIKVISION DS-2TD2608-2/QA/FP User Manual

2.
Check Enable Open Network Video Interface.
3.
Click Add to congure the Open Network Video Interface user.
Delete Delete the selected Open Network Video Interface user.
Modify Modify the selected Open Network Video Interface user.
4.
Click Save.
5.
Oponal: Repeat the steps above to add more Open Network Video Interface users.
3.10 Set Alarm Host
The device can send the alarm signal to the remote alarm host when an event occurs. The alarm
host refers to the PC installed with client
soware.
Steps
1.
Go to Conguraon → Network → Other .
2.
Enter the alarm host IP and port.
3.
Click Save.
3.11 Set Alarm Server
The device can send alarms to desnaon IP address or host name through HTTP, HTTPS, or ISUP
protocol. The desnaon IP address or host name should support HTTP, HTTP, or ISUP data
transmission.
Steps
1.
Go to
Conguraon → Network → Advanced Sengs → Alarm Server .
2.
Enter Desnaon IP or Host Name, URL, and Port.
3.
Select Protocol.
Note
HTTP, HTTPS, and ISUP are selectable. It is recommended to use HTTPS, as it encrypts the data
transmission during communicaon.
4.
Click Test to check if the IP or host is available.
5.
Click Save.
3.12 Set Network Service
You can control the ON/OFF status of certain protocol as desired.
Thermal Opcal Bi-spectrum Network Camera User Manual
11

HIKVISION DS-2TD2608-2/QA/FP Specifications

General

Brand	HIKVISION
Model	DS-2TD2608-2/QA/FP
Category	Security Camera
Language	English