HIKVISION DS-2TD2608-2/QA/FP User Manual

Steps
1.
Check Enable Auto Trigger.
2.
Set Trigger Time, and the device will trigger an alarm output to the alarm server automacally in
the set
me.
3.
Set Auto Trigger Delay. It refers to the me duraon that the alarm output remains in eect
aer
the auto trigger.
4.
Click Save.
9.2.2 FTP/NAS/Memory Card Uploading
If you have enabled and congured the FTP/NAS/memory card uploading, the device sends the
alarm
informaon to the FTP server, network aached storage and memory card when an alarm is
triggered.
Refer to Set FTP to set the FTP server.
Refer to
Set NAS for NAS conguraon.
Refer to Set Memory Card for memory card storage conguraon.
9.2.3 Send Email
Check Send Email, and the device sends an email to the designated addresses with alarm
informaon when an alarm event is detected.
For email
sengs, refer to Set Email .
Set Email
When the email is congured and Send Email is enabled as a linkage method, the device sends an
email
nocaon to all designated receivers if an alarm event is detected.
Before You Start
Set the DNS server before using the Email funcon. Go to Conguraon → Network → Basic
Sengs → TCP/IP for DNS sengs.
Steps
1.
Go to email sengs page: Conguraon → Network → Advanced Sengs → Email .
2.
Set email parameters.
1) Input the sender's email
informaon, including the Sender's Address, SMTP Server, and
SMTP Port.
2)
Oponal: If your email server requires authencaon, check Authencaon and input your
user name and password to log in to the server.
3) Set the E-mail
Encrypon.
Thermal Opcal Bi-spectrum Network Camera User Manual
59

HIKVISION DS-2TD2608-2/QA/FP Specifications

General

Model	DS-2TD2608-2/QA/FP
Sensor Type	Thermal
Pixel Interval	17 μm
Aperture	F1.0
Image Sensor (Visible)	1/2.7" Progressive Scan CMOS
Alarm	1 input, 1 output
Focus	Fixed
Type	Bullet
Response Waveband	8 μm ~ 14 μm
Thermal Sensitivity	≤ 50 mK
Lens	2 mm
Image Enhancement	AGC, 3D DNR
Image Display	3D DNR
Video Compression	H.265/H.264
Audio Compression	G.711u/G.722.1/G.726/MP2L2
Protocols	TCP/IP, ICMP, HTTP, HTTPS, FTP, DHCP, DNS, DDNS, RTP, RTSP, RTCP, NTP, UPnP, SMTP, SNMP, IGMP, 802.1X, QoS, IPv6, Bonjour
Network Interface	RJ45 10M/100M Ethernet
Audio	1 input, 1 output
Power	DC12V, PoE (802.3af)
Power Supply	12 VDC ± 20%, PoE (802.3af)
Operating Temperature	-30 °C ~ 60 °C (-22 °F ~ 140 °F)
Dimensions	221.2 mm × 94.9 mm × 82.5 mm
Weight	770 g
Human Temperature Measurement Range	30 °C to 45 °C (86 °F to 113 °F)
Human Temperature Measurement Accuracy	± 0.5 °C (± 0.9 °F)