HIKVISION DS-2TD2608-2/QA/FP User Manual

Detecon Funcon Parameter Descripon
The higher the value is, the more easily the
re source of lower temperature can be
detected, and the higher the false alarm
rate is.
Smoke Detecon Display Smoke Source Frame on Stream
Display a red frame around the smoke
source on stream when smoke occurs.
Sensivity
The higher the value is, the more easily the
smoke can be detected, and the higher the
false alarm rate is.
Vericaon Sensivity
The higher the value is, the more quickly
the device can double-check and idenfy
the smoke, and the higher the false alarm
rate is.
Note
Smoke Detecon is not supported when Day/Night Switch mode is Night or when the device
idenes the environment as night.
5.
Oponal: Go to Smart Event → Smoke Detecon Shield . You can shield certain areas from
being detected in smoke detecon, refer to .
6.
Refer to
Set Arming Schedule for seng scheduled me. Refer to Linkage Method Sengs for
seng linkage method.
7.
Click Save.
4.2.3 Set Dynamic Fire Source
Detecon
To avoid the potenal re damage, you can congure the re detecon funcon for certain areas.
The detail
conguraon steps show as below.
Steps
1.
Go to Conguraon → Local .
2.
Check Locate Highest Temperature Point to display the posion of highest temperature. Check
Frame Fire Point to frame the
re source on live view.
3.
Go to Conguraon → Event → Smart Event , select Dynamic Fire Source Detecon.
4.
Check Enable Dynamic Fire Source
Detecon.
5.
Set the parameters of re detecon.
Fire Source Detecon
Thermal Opcal Bi-spectrum Network Camera User Manual
28

HIKVISION DS-2TD2608-2/QA/FP Specifications

General

Brand	HIKVISION
Model	DS-2TD2608-2/QA/FP
Category	Security Camera
Language	English