6.2.14 Brightness Sudden Change
When the brightness of target and the background is hugely dierent (the temperature dierence
of target and background is huge), the system reduces the dierence for viewing.
6.2.15 Enhance Regional Image
You can select the desired area of image to improve the coding quality. The regional image will be
more detailed and clear.
Steps
1.
Go to Conguraon → Image → Display Sengs → Image Enhancement .
2.
Select the area of regional image enhancement. You can select OFF to disable this
funcon, or
select Custom Area to draw a desired area.
A red rectangle shows on the display, in which the image quality is improved.
6.2.16 Mirror
When the live view image is the reverse of the actual scene, this funcon helps to display the
image normally.
Select the mirror mode as needed.
Note
The video recording will be shortly interrupted when the funcon is enabled.
6.2.17 Video Standard
Video standard is an ability of a video card or video display device that denes the amount of
colors that are shown and the resoluon. The two most common video standard used are NTSC
and PAL. In NTSC, 30 frames are
transmied each second. Each frame is made up of 525 individual
scan lines. In PAL, 25 frames are transmied each second. Each frame is made up of 625 individual
scan lines. Select video signal standard according to the video system in your country/region.
6.2.18 Digital Zoom
You can zoom in the image. The larger the zoom size is, the more blurred the image is.
6.2.19 Local Output
Enter a short descripon of your concept here (oponal).
Thermal Opcal Bi-spectrum Network Camera User Manual
44
To Next Page
Loading...
Need help?
General
