HIKVISION DS-2TD2608-2/QA/FP User Manual

View the version of calibraon le.
Alarm Interval
Set the alarm interval between two alarms.
4.
Go to Temperature Measurement → Advanced Sengs → Algorithm Filter to lter false alarm.
Reect Light Filter
Enable these funcons if there is strong reected light from sun, or it may cause false alarm.
The
lter sensivity can be adjusted.
Check Display Filtering Status, and an OSD will be displayed when the funcon is enabled.
Click Restart to restart the algorithm library of reect light lter.
Smoking Filter
Check Enable Smoking Filter to lter out high temperature alarms triggered by smoking.
Check Display Filtering Status, and an OSD will be displayed when the
funcon is enabled.
Click Restart to restart algorithm library of smoking lter.
5.
Click Save.
Set Normal Mode
This funcon is used to measure the temperature of the whole scene and alarm.
Steps
1.
Go to Conguraon → Temperature Measurement & Fire Prevenon → Basic Sengs , and
check Enable Temperature Measurement.
2.
Refer to
Set Thermography Parameters to set the parameters.
3.
Go to Conguraon → Temperature Measurement & Fire Prevenon → Advanced Sengs ,
and select Normal.
4.
Congure the parameters of normal mode.
Emissivity
Set the emissivity of your target. The emissivity of each object is
dierent.
Distance
The distance between the target and the device.
Pre-Alarm Threshold and Filtering Time
When the temperature of target exceeds the Pre-Alarm Threshold and this status lasts not
shorter than the Filtering Time, the pre-alarm is triggered.
Alarm Threshold and Filtering Time
When the temperature of target exceeds the Alarm Threshold, and this status lasts not
shorter than the Filtering Time, the alarm is triggered.
Pre-Alarm Output and Alarm Output
Thermal Opcal Bi-spectrum Network Camera User Manual
20

HIKVISION DS-2TD2608-2/QA/FP Specifications

General

Brand	HIKVISION
Model	DS-2TD2608-2/QA/FP
Category	Security Camera
Language	English