User Manual of Digital Video Recorder
187
the RAID, and cannot detect the bad sector.
Foreground (Recommended): By using foreground initialization, the RAID will be initialized totally
and the bad sector of the hard disks can be detected and repaired. The virtual disk can be used only
after the initialization is complete.
Background: The background initialization can synchronize the disks, and detect and repair the bad
sector of the disks. During the background initialization, the virtual disk is allowed to be used.
8. Click Apply to save the settings and click OK to return to Array Settings interface.
9. Click Virtual Disk tab to enter the Virtual Disk interface. The successfully created virtual disk will be listed
on the interface.
Figure 10. 11 Virtual Disk Interface
10. Enter the HDD Information interface (Menu>HDD>General) and the virtual disk will be displayed. For
operation guide of initializing the virtual disk, please refer to Chapter 11.1 Initializing HDDs.
If you adopt foreground initialization, the virtual disk will be displayed in the HDD Information interface
after the initialization is complete.
Figure 10. 12 HDD Information Interface
11. Enter the Physical Disk Settings interface to configure the hot spare disk.
Figure 10. 13 Physical Disk Settings Interface
12. Select a free disk and click the icon . Then the free disk will be set as the global hot spare disk.
You can click the icon to delete the hot spare disk.
To Next Page
Loading...
Need help?
General