HIKVISION DS-K1T320 Series - Chapter 11 Environment Settings; Environment Settings

HTTPS
Set the HTTPS for accessing the browser. Cercate is required when accessing.
Server
It refers to the port through which the client adds the device.
Plaorm Access
Plaorm access provides you an opon to manage the devices via plaorm.
Steps
1.
Tap Conguraon → Network → Advanced → Hik-Connect to enter the sengs page.
Note
Hik-Connect is an applicaon for mobile devices. With the App, you can view live image of the
de
vice, receive alarm nocaon and so on.
2.
Check Enable t
o enable the funcon.
3.
Enter the server address and stream encrypon.
Note
6 to 12
leers (a to z, A to Z) or numbers (0 to 9), case sensive. You are recommended to use a
combinaon of no less than 8 leers or numbers.
4.
Y
ou can view Register Status and Device QR Code.
5.
Tap Save to enable the sengs.
Set ISUP Parameters
Set the ISUP parameters for accessing device via ISUP protocol.
St
eps
Note
The
funcon should be supported by the device.
1.
T
ap Conguraon → Network → Advanced → ISUP .
2.
Check Enable.
3.
Set the ISUP version, IP Address, Port, and Account.
Note
If you select 5.0 as the version, you should set the encrypon key as well.
4.
Se
t the Center Group.
Center Group
Select a center group from the drop-down list.
DS-K1T320 Series Face
Recoginon Terminal User Manual
60