HIKVISION DS-K1T981 Series User Manual

Set the device building No.
Unit No.
Set the device unit No.
Note
If you change the No., you should reboot the device.
If set the device type as Out
er Door Staon, you can set the period No., outer door staon No.,
and community No.
Outer Door Staon No.
If you select outer door staon as the device type, you should enter a number between 1 and
99.
Note
If you change the No., you should reboot the device.
Phase No.
Se
t the device phase No.
Congure SIP Parameters
Set the device's IP address and the SIP server's IP address. Aer seng the parameters, you can
communicate among the access control device, door staon, indoor staon, main staon, and the
plaorm.
Note
Only the access control device and other devices or systems (such as door staon, indoor staon,
main staon,
plaorm) are in the same IP segment, the two-way audio can be performed.
Go to Conguraon → Video In
tercom → Linked Network Sengs .
Set the main staon's IP address and SIP server's IP address.
Click Save.
Press Buon to Call
Steps
1. Click In
tercom → Press Buon to Call t
o enter the sengs page.
2. Set the parameters.
-
Edit call No. for every buon.
-
Check Call Manag
ement Center to set the buon calling center.
DS-K1T981 Series Access Control Terminal User Manual
99

HIKVISION DS-K1T981 Series Specifications

General

Brand	HIKVISION
Model	DS-K1T981 Series
Category	Touch terminals
Language	English