HIKVISION DS-K1T981 Series

●
If you do not congure the applicaon mode and tap Next, the system will select Indoor by
default.
●
If you acvate the device via other tools remotely, the system will select Indoor as the
applicaon mode by default.
6.2 Set Network Parameters
Aer acvaon and select applicaon mode, you can set the network for the device
Steps
1. When you enter the Select Network page, tap Wired Network or Wi-Fi for your actual needs.
Figure 6-2 Select Network
Note
Disconnect the wired network before connecng a Wi-Fi.
2. T
ap Next.
DS-K1T981 Series Access Control Terminal User Manual
31