HIKVISION DS-K1T981 Series

8.5.2 View Device Informaon
View the device name, language, model, serial No., QR code, version, number of channels, alarm
input, alarm output, lock and RS-485, device capacity, etc.
Click Conguraon → System → System Sengs → Basic Informaon to enter the conguraon
page.
You can view the device name, language, model, serial No., QR code, version, number of channels,
alarm input, alarm output, lock and RS-485, device capacity, etc.
Note
You can view face, card, ngerprint, event and Iris capacity of the device.
8.5.3 Set Time
Set the device's
me zone, synchronizaon mode, and the device me.
Click Conguraon → System → System Sengs → Time Sengs .
Click Save to save the sengs aer the conguraon.
Time Zone
Select the device located me zone from the drop-down list.
Time S
ync.
NTP
You should set the NTP server's IP address, port No., and interval.
Manual
By default, the device me should be synchronized manually. You can set the device me
manually or check S
ync. with Computer Time to synchronize the device me with the
computer's me.
8.5.4 Set DST
Steps
1. Click Conguraon → S
ystem → System Sengs → DST .
Figure 8-3 DST Page
DS-K1T981 Series Access Control Terminal User Manual
76