HIKVISION DS-K1T981 Series

9.4.4 Issue Cards to Persons in Batch
The client provides a convenient way to issue cards to mulple persons in a batch.
Steps
1. Enter Person module.
2. Click Batch Issue Cards.
All the added persons with no card issued will be displayed in the right panel.
3. Oponal: Enter key words (name or person ID) in the input box to lter the person(s) that need
issuing cards.
4. Oponal: Click Sengs to set the card issuing parameters. For details, refer to .
5. Click Inialize to inialize the card enrollment staon or card reader to make it ready for issuing
cards.
6. Click the Card No. column and enter the card number.
-
Place the card on the card enrollment staon.
-
Swipe the card on the card reader.
-
Manually enter the card number and press the Enter key.
The person(s) in the list will be issued with card(s).
9.4.5 Report Card Loss
If the person lost his/her card, you can report the card loss so that the card's related access
authorizaon will be inacve.
Steps
1. En
ter Person module.
2. Select the person you want to report card loss for and click Edit to open the Edit Person window.
3. In the Credenal → Card panel, click
on the added card to set this card as lost card.
Aer reporng card loss, the access
authorizaon of this card will be invalid and inacve. Other
person who gets this card cannot access the doors by swiping this lost card.
4. Oponal: If the lost card is found, you can click
to cancel the loss.
Aer cancelling card loss, the access authorizaon of the person will be valid and acve.
5. If the los
t card is added in one access group and the access group is applied to the device
already, aer reporng card loss or cancelling card loss, a window will pop up to nofy you to
apply the changes to the device. Aer applying to device, these changes can take eect on the
device.
9.4.6 Set Card Issuing Parameters
The client provides two modes for reading a card's number: via card enrollment staon or via the
c
ard reader of the access control device. If a card enrollment staon is available, connect it to the
PC running the client by USB interface or COM, and place the card on the card enrollment to read
DS-K1T981 Series Access Control Terminal User Manual
120