HIKVISION DS-K1T981 Series

Note
The page may vary according to dierent device models. Refers to the actual page for details.
Capacity
Y
ou can view the number of user, face picture, card, event, ngerprint and iris.
Upgrade
Plug the USB ash drive in the device USB interface. Tap Upgrade → OK , and the device will
read the digicap.dav le in the USB ash drive to start upgrading.
Unlink APP Account
Unlink the Hik-Connect account from the plaorm.
Restore to Default
All parameters, except for the communicaon sengs, remotely imported user informaon, will
be restored to the default sengs. The system will reboot to take eect.
Restore to Factory
All parameters will be restored to the factory sengs. The system will reboot to take eect.
Reboot
The device will reboot aer the
conrmaon.
Long tap , and en
ter admin password to view device version informaon.
7.11 Video Intercom
Aer adding the device to the client soware, you can call the device from the client soware, call
the main staon from the device, call the client soware from the device, or call the indoor staon
from the device.
7.11.1 Call Client Soware from Device
Steps
1. Ge
t the client soware from the supplied disk or the ocial website, and install the soware
according to the prompts.
2. Run the clien
t soware and the control panel of the soware pops up.
3. Click Device Management to enter the Device Management interface.
4. Add the device to the client soware.
Note
For details about adding device, see Add De
vice.
5. Call the clien
t soware.
DS-K1T981 Series Access Control Terminal User Manual
68