HIKVISION DS-K1T981 Series User Manual

Note
If you can not nd Device Parameter in the Advanced Funcon list, hover the cursor on the
Adv
anced Funcon, and then Click
to select the Device Parameter to be displayed.
2. Select an access de
vice to show its parameters on the right page.
3. Turn the switch to ON to enable the corresponding funcons.
Note
●
The displa
yed parameters may vary for dierent access control devices.
●
Some of the following parameters are not listed in the Basic Informaon page, click More to
edit the parameters.
RS-485 Comm. Redundancy
Y
ou should enable this funcon if you wire the RS-485 card reader to the access control
device redundantly.
Display Detected Face
Display face picture when authencang.
Display Card Number
Display the card informaon when authencang.
Display Person Informaon
Display the person informaon when
authencang.
Overlay Person Info. on Picture
Display the person informaon on the captured picture.
Voice Prompt
If you enable this funcon, the voice prompt is enabled in the device. You can hear the voice
pr
ompt when operang in the device.
Upload Pic. Aer Linked Capture
Upload the pictur
es captured by linked camera to the system automacally.
Save Pic. Aer Linked Capture
If you enable this funcon, you can save the picture captured by linked camera to the device.
Pr
ess Key to Enter Card Number
If you enable this funcon, you can input the card No. by pressing the key.
Wi-Fi Probe
If you enable this funcon, the device can probe the surrounding communicaon devices'
MAC address and upload the MAC address to the system. If the MAC address match the
specied MAC address, the system can trigger some linkage acons.
NFC An-Cloning
If you enable this funcon, you cannot use the cloned card for authencaon and further
enhance security
.
DS-K1T981 Series Access Control Terminal User Manual
127

HIKVISION DS-K1T981 Series Specifications

General

Brand	HIKVISION
Model	DS-K1T981 Series
Category	Touch terminals
Language	English