HIKVISION DS-K1T981 Series User Manual

The door can be locked once it is closed even if the Door Locked Time is not reached.
Duress Code
The door can open by inpung the duress code when there is duress. At the same me, the
client can report the duress event.
Super Password
The specic person can open the door by inpung the super password.
Dismiss Code
Create a dismiss code which can be used to stop the buzzer of the card reader (by entering
the dismiss code on the keypad).
Note
●
The dur
ess code, super code, and dismiss code should be dierent.
●
The duress code, super password, and the dismiss code should be dierent from the
authencaon password.
●
The length of duress code, super password, and the dismiss code is according the device,
usually it should contains 4 to 8 digits.
5. Click OK.
6. Oponal: Click Cop
y to , and then select the door/oor(s) to copy the parameters in the page to
the selected doors/oor(s).
Note
The door or oor's status duraon
sengs will be copied to the selected door/oor(s) as well.
Congure Parameters for Card Reader
Aer adding the access control device, you can congure its card reader parameters.
Be
fore You Start
Add access control device to the client.
Steps
1. Click Access Control → Advanced Funcon → De
vice Parameter .
2. In the device list on the le, click
to expand the door, select a card reader and you can edit the
c
ard reader's parameters on the right.
3. Edit the card reader basic parameters in the Basic Informaon page.
Note
●
The displa
yed parameters may vary for dierent access control devices. There are part of
parameters listed as follows. Refer to the user manual of the device for more details.
●
Some of the following parameters are not listed in the Basic Informaon page, click More to
edit the parameters.
DS-K1T981 Series Access Control Terminal User Manual
129

HIKVISION DS-K1T981 Series Specifications

General

Brand	HIKVISION
Model	DS-K1T981 Series
Category	Touch terminals
Language	English