HIKVISION DS-K1T981 Series - Page 76

Figure 7-13 Access Control Parameters
The a
vailable parameters descripons are as follows:
Table 7-3 Access Control Parameters Descripons
Parameter Descripon
Terminal Auth. Mode (Terminal
Authencaon Mode)
Select the device's authencaon mode. You can also customize
the authencaon mode.
Note
●
Only the de
vice with the ngerprint module supports the
ngerprint related funcon.
●
Biometric recognion products are not 100% applicable to
an-spoong environments. If you require a higher security
level, use mulple authencaon modes.
●
If you adopt mulple authencaon modes, you should
authencate other methods before authencang face.
Reader Auth. Mode (Card
Reader Authencaon Mode)
Select the card reader's authencaon mode.
Enable NFC Card Enable the funcon and you can present the NFC card to
authencate.
Door Contact You can select "Open (Remain Open)" or "Close (Remian
Closed)" according to your actual needs. By default, it is Close
(Remian Closed).
DS-K1T981 Series Access Control Terminal User Manual
62